DRT Oil Seal crankshaft clutch side 32x61x7 mm for Vespa 160 GS/180 SS
- Viton High Quality
OEM numbers (for comparisons): 077975 – 077975 (PIAGGIO)
Radial shaft oil seals should be installed firmly into the crankcase for a tight and secure fit. The inner circumference of the ring is the contact point to the rotating shaft and is mostly held in place with a circular spring to keep it sealed tight around the shaft. These items wear out regularly and should be replaced during every service of your motor. If the motor has not been run for a while the seals could be damaged. If the revs of your motor increase while it should be ticking over, the oil seal on the flywheel side of the crankshaft is probably defective or damaged. If you discover fuel mixed with your gearbox oil, the oil seal that sits on the clutch side of the crankshaft is the likely suspect.
Helpful hint: As a rule of thumb, to ensure correct positioning of your fresh oil seals, the ‘open’ side of the seal always faces towards the one of the chambers that it separates, with the higher pressure. This higher pressure also helps the inner circumference maintain the seal to the shaft by pushing the inner edge against it.